2 stage ejection
By SDM
Published: August 1st, 2011
Published: August 1st, 2011
Hi,,,,, am designing a 2 stage mould stripper for 5mm then stop then ejection pins to remove the part. I don't want to use the DME type system am looking for a more simplistic approach. The stripper plate can't move until the slides are fully back away from the angle pins. There's also a angled hyd slide which is only in it's out position once the moving half is back. Any Dwgs please send to SM@totaltoolmanagement.com
- Login or register to post comments
Email this page
Use air to move the stripper;
Use air to move the stripper; just need to machine 2 pistons and add a groove for the pnuematic seal.
Next, use the KO bars on the machine to push the ejectors; just need to make your own ejector plates.
Both are easy to make and reliable.
Both can be indepentently controlled from the moulding machine.
Try it.
Paul.