Post Mold Cooling Tooling
By plaztikman
Published: March 12th, 2010
Published: March 12th, 2010
I am looking for information on suppliers of Post Mold Cooling Tooling.
I am looking to purchase preform tooling (molds + take out plate + cooling pin plate) for a HyPet machine, but I am having difficulty in finding suppliers for the post mold cooling tooling other than Husky.
I know of dozens of mold makers who will supply the mold, but I would prefer to purchase the complete package from one source.
Any suggestions?
Email this page
It is not a big job! Dukemen
It is not a big job!
Dukemen can supply the whole PET production line.
19g PET Preform, 48 cavities. Using 400T IMM with 3-station Robot to take out the products, cycle time is 10 seconds. The Preform is cooled in the robot, instead of in the mold.
For more information, you may check: www.dukemen.com
Post new comment