RE: Battenfeld doesn't close and doesn't eject

By Ace
Published: August 25th, 2008

We have two Battenfeld BA 350/050, with Unilog 4000, all the switches and sensors are working properly but in manual mode we can not close the m

Login or register to post comments
Email this page

The question was posted in

Submitted by Anonymous on December 14, 2011 - 6:24pm.

The question was posted in 2008, I think the presses have closed by now! Or maybe the Molder has retired?

Keep on Molding and Merry Christmas (Happy Holidays)!

brent

Check for proper pump

Submitted by Anonymous on December 13, 2011 - 7:58pm.

Check for proper pump rotation,pump coupling,check your voltage on y19 speed valve y8 pressure valve.Do you have any pressure at all.does your nozzle move? Any alarms on the screen?Write more

We have the same problem. We

Submitted by Anonymous on April 16, 2011 - 1:04pm.

We have the same problem. We belive that it has something to do with shunting, and the hydralic fluid must be 'diverted' somewhere else in the system...But we can't figure out how to 'shunt'.

We have the same problem. We

Submitted by Anonymous on April 16, 2011 - 1:04pm.

We have the same problem. We belive that it has something to do with shunting, and the hydralic fluid must be 'diverted' somewhere else in the system...But we can't figure out how to 'shunt'.

Hi Are you getting any

Submitted by jag on November 24, 2009 - 10:01am.

Hi Are you getting any hydraulic movement for example carrage,ejectors also is their any way you can check hydraulic pressure if no pressure check coupling between motor and pump somtimes it is not possible to see this i always use my mobile phone to film it.
It is common fault for the cuplings to break as they are made out of alloy.
Hope it helps.