Welcome to the Extrusion Forum

Bonjour, excusez mais je ne

Submitted by Anonymous on November 10, 2011 - 2:45am.

Bonjour, excusez mais je ne parle pas anglais. Ma question est pourquoi quand on fraise un profile, il casse de temps en temps mais pas régulièrement ?

Login or register to post comments

We have ZSK 83 mm

Submitted by Anonymous on September 14, 2011 - 1:01am.

We have ZSK 83 mm intermeshing, co-rotating twin screw extruder cascaded by ESA 200 single screw extruder for rigid pvc pelletezing process. The total kneading length (3x29 mm & 1x9mm-middle and 3x9mm before the exit) is 123 mm. The total screw length is 1.2 m. During production the ZSK torque is varying from 70 to 100 %. Some times even the torque goes below 50 and powder material comes out. please suggest some remedy for this problem.

sankarvalli72@yahoo.com

Login or register to post comments

We have ZSK 83 mm

Submitted by Anonymous on September 14, 2011 - 12:59am.

We have ZSK 83 mm intermeshing, co-rotating twin screw extruder cascaded by ESA 200 single screw extruder for rigid pvc pelletezing process. The total kneading length (3x29 mm & 1x9mm-middle and 3x9mm before the exit) is 123 mm. The total screw length is 1.2 m. During production the ZSK torque is varying from 70 to 100 %. Some times even the torque goes below 50 and powder material comes out. please suggest some remedy for this problem